Dot Voting

Run a live dot-voting round to prioritise as a group.

Applies To

livediagram and liveplanner

Dot-voting is a quick way for a group to prioritise. Each participant gets a budget of dots to spend on the things they care about most, the dots tally up live, and you reveal the winners at the end.

Running a Vote

Set the Dots per person by tapping the row of dots (tap the fifth for five each; anywhere from 1 to 10, starting at 3). With more than one dot, choose whether people can stack dots under Dots per item (Any number, or One each so every dot goes on a different item). Decide the two privacy switches, then choose Start vote. The popover becomes the Vote panel, and the Vote button of everyone who can cast (Editors and Participants) counts the dots they have left.

While the vote is open, participants put dots on what they want to back. The Vote panel shows your own dots left at the top and how far through the room you are underneath. On a desktop it stays open while the vote runs, until you press the Vote button again.

Choose End vote to close casting (the tallies stay put), then Show results to start the guided results walkthrough, or Clear to skip it. During the walkthrough, Done on the last pick, or Clear vote at any point, puts the tab back. All of these are on the Vote panel, so you never have to leave it mid-session.

Who Drives a Vote

A vote belongs to whoever started it. Only they can end it. The same goes for the rest: reveal the results, clear it, or move the walkthrough; everyone else's Vote panel says so in place of the buttons. You can always run another vote, but you can't get the dots back, so an accidental End vote from a participant would cost the room the whole round.

Starting a vote needs edit access. Visitors on a Participant link cast dots like editors; on a Viewer share link they can watch the counts, the reveal, and the walkthrough but cannot cast a dot, so observers see the outcome without skewing it. A tab runs one vote at a time, and each tab can run its own.

A common rule of thumb is roughly one dot per three or four options. Set the dots before you start the vote, then leave it: keeping budgets small forces real choices.

Was this article helpful?

Still need help?

Try Troubleshooting, or tell us what you were trying to do.

Contact us